tributesinwood

Wood Carvings by Mark Sheridan

Archive for the tag “Fender Guitar”

Al’s Fender Bender

Well I had fun doing this carving as it was a bit of a departure from my other caricature carvings in that it was meant to resemble a specific person.

My friend, Pat, asked me to do a caricature of her husband, Al, ( also a friend!) doing what he enjoys…rocking on with his Fender guitar and amp. As it was a birthday surprise that he only received this past Friday and as he and Pat tend to follow what I’m doing on this blog, I had to wait to publicize things…so, here it is!

I started with a few photos that Pat sent me and downloaded a few additional photos of the Fender Stratocaster and amplifier that Al owns. Once again, I did the figure in clay and then used the clay figure as a model for the carving. The clay work was particularly helpful when modelling the face…I think that I would have gone through a lot of failed attempts if I had tried to do the initial resemblance in wood!

I actually started with the guitar and amp. The guitar is made from oak and I cut out the blank and added details based on a print-out that I made from a local music shop website…the nice part of doing this is that I was able to make the exact size that I wanted by reducing the print size to what I wanted and then just cut it out on the bandsaw. After some carving, some acrylic paint to simulate the wood grain and several coats of gloss urethane…pins, nails, metal tape and fine wire went into making up all of the details. The amp was made from basswood and includes some screws and metal tape. The amp screen was produced with a v-tool and several coats of alternating white and silver acrylic paint.

I did my typical carving of the head and hat separately using calipers that you see in the photo for measuring from the clay and then started into the body.

Once again, I kept the arms separate so that the grain direction of the wood was aligned as best as possible along the length of the arms. I had considered an additional joint at the one elbow but felt that the grain direction was pretty good and that glueing and pinning the “strumming” arm to the guitar would give it ample strength…plus, Al’s pretty careful with things!

The base is maple with a few lines that simulate floor planking. A few buttons ( decorative nails ) were added to what became a leather jacket and the Fender logos were painted on the guitar, amp and t-shirt.

I really enjoyed this project but the most enjoyment, by far, came from the smile on Al’s face!

Advertisements

Post Navigation